top of page
Writer's pictureJolie & Mark

TROOPY RUNDOWN - INTERIOR FITOUT

Updated: Oct 16, 2020

THE INTERIOR

The floor was stripped, cleaned and repainted.  

Direct stick sound deadening was used from the fire wall to behind the front seats.  

This was then covered with a thicker thermal/acoustic insulation.

A 9mm ply was cut in to the rear to provide a flat floor. Direct stick water proof vinyl floorboards were then fixed straight to the ply.

The original hard vinyl 'one and three quarter' seats needed to go for two reasons.​

1. They weren't ideal for long trips, and,

2. They didn't allow direct access into the back.

We fabbed some brackets to allow a pair of leather ute seats to be installed.  With lumber support, the ability to flip forward and additional bolstering they are much more comfortable and practical!

 

ELECTRICAL

Prior to us buying the car the wiring had been attempted several times  and there was poor connections and dead cabling everywhere.  


The dash was removed then all accessories cabling  was stripped out and removed.

A new fuse block was installed behind the drivers seat to service all the rear electrical requirements including fridge, lighting, water pump and 12v cig and USB sockets.

A 70amp circuit breaker was fixed next to the secondary battery in the engine bay.

 

CABINETRY



The vehicle was brought with a twin drawer setup in the rear made from a 17mm form ply.

This was cut down and completely recycled into the kitchenette and rear seating.

The kitchenette includes the Engel, SMEV sink (including fold down hot/cold taps and glass top), two large drawers, shoe/general storage and two other cupboards for food and misc items.

The front of the kitchen is covered with 15mm ply and stained and varnished.  The bench top is a 20mm laminated pine finished in a hard wearing semi gloss super enamel.

Adjacent to the kitchenette is the seating. The seats have hinged tops on gas struts and are room for clothing and other large items.  There is a smaller section at the rear near the door to hold tools.

The seat cushions and backrests are made from high density memory foam and custom covers which all conveniently fold down to make another bed or seating for four!

 

Watch the Youtube video HERE!





7,838 views0 comments

Recent Posts

See All

Comments


bottom of page